Legal radio: video and control link

Which channels your video transmitter may use in Germany, how much power is allowed and what applies to the control link on 2.4 GHz and 868 MHz. The basis is the Bundesnetzagentur's general authorisation for short-range devices, as of 5 November 2026. This is not legal advice, it is a summary of the linked sources. Quotes from German legal texts are our translations.

The short version

  • Video on 5.8 GHz: only 5725 to 5875 MHz, at most 25 mW EIRP.
  • Control link on 2.4 GHz: at most 100 mW EIRP for wideband modulation such as frequency hopping, otherwise 10 mW EIRP.
  • EIRP includes the antenna. 25 mW at the transmitter plus an antenna with gain is more than 25 mW EIRP.
  • Only devices that comply with the Radio Equipment Act. The authorisation says frequencies may only be used with radio equipment that complies with the Funkanlagengesetz (FuAG).

Anyone may use these frequencies without an individual licence; the Bundesnetzagentur sets this out in Vfg. 91/2025, valid until 31 December 2035. It implements an EU decision, so the same bands apply across the EU. Individual countries may allow more: according to the authorisation, the EU decision lets member states permit the use of the bands under less strict conditions. For bands 61, 57a and 57c the values in Germany are the same.

The rows from the authorisation

Band, frequencyLimitFor
61
5725–5875 MHz
25 mW (EIRP)non-specific short-range devices
57c
2400–2483.5 MHz
100 mW (EIRP)wideband data transmission devices; power density of 100 mW/100 kHz (EIRP) with frequency hopping
57a
2400–2483.5 MHz
10 mW (EIRP)non-specific short-range devices

Band 61 covers video transmitters, because in the authorisation "non-specific" means any radio device that meets the technical conditions of the band, whatever its purpose. Band 57c applies to "wideband data transmission devices", and the row explicitly mentions frequency hopping. Vfg. 91/2025, tables 1 and 2

What EIRP means

The limits are given as EIRP, which the Bundesnetzagentur defines as the product of the power delivered to the antenna and the antenna gain in a given direction relative to an isotropic antenna. Vfg. 76/2025, no. 1.3 So the transmitter setting is not the whole story: the antenna concentrates power in its main direction, and that counts. With 25 mW at the transmitter:

Antenna gainEIRP at 25 mW
0 dBi25 mW
2 dBi40 mW
3 dBi50 mW
5 dBi79 mW

Cables and connectors before the antenna lose some power, which lowers the EIRP again. You will find your antenna's gain in its specifications.

Video on 5.8 GHz: which channels

The default table in the Betaflight source code has five bands with eight channels each. For every channel you can see whether its center lies inside the permitted band.

Analog 5.8 GHz channels: is the center inside the permitted band 5725–5875 MHz?

Boscam A center in band: 8 of 8

  • A15865! close to the edge
  • A25845✓ in band
  • A35825✓ in band
  • A45805✓ in band
  • A55785✓ in band
  • A65765✓ in band
  • A75745✓ in band
  • A85725! close to the edge

Boscam B center in band: 8 of 8

  • B15733! close to the edge
  • B25752✓ in band
  • B35771✓ in band
  • B45790✓ in band
  • B55809✓ in band
  • B65828✓ in band
  • B75847✓ in band
  • B85866! close to the edge

Boscam E center in band: 0 of 8

  • E15705✕ outside
  • E25685✕ outside
  • E35665✕ outside
  • E45645✕ outside
  • E55885✕ outside
  • E65905✕ outside
  • E75925✕ outside
  • E85945✕ outside

FatShark center in band: 7 of 8

  • F15740✓ in band
  • F25760✓ in band
  • F35780✓ in band
  • F45800✓ in band
  • F55820✓ in band
  • F65840✓ in band
  • F75860✓ in band
  • F85880✕ outside

RaceBand center in band: 4 of 8

  • R15658✕ outside
  • R25695✕ outside
  • R35732! close to the edge
  • R45769✓ in band
  • R55806✓ in band
  • R65843✓ in band
  • R75880✕ outside
  • R85917✕ outside

Only the center frequency is checked. A video signal occupies more than one frequency, so channels marked “close to the edge” (center at most 10 MHz from the band edge) are uncertain. How wide your transmitter’s signal is can be found in its specifications.

Channels: Betaflight source code vtx_table.c · Band: Bundesnetzagentur Vfg. 91/2025 (5725–5875 MHz, 25 mW EIRP)

Raceband R1, R2, R7 and R8, all of band E and FatShark channel F8 are outside. In Betaflight you set this in the Video Transmitter tab under Band, Channel and Power, or in the CLI with vtx_band, vtx_channel and vtx_power. vtx_power is the level from your transmitter's VTX table, not the number in mW. Betaflight cli/settings.c

Digital video systems

Digital systems also transmit in the 5.8 GHz band. The manufacturers state:

  • DJI O4 Air Unit: 5.725 to 5.850 GHz, for the EU (CE) below 14 dBm EIRP, which is about 25 mW. DJI also lists 5.170 to 5.250 GHz. That band is not part of the authorisation for short-range devices, and this guide does not cover it. DJI specifications
  • HDZero Race V3 and Freestyle V2: 5.725 to 5.850 GHz, power 25 mW or 200 mW. On the Freestyle V2, HDZero only unlocks up to 900 mW on channel R1 with a licence or approval from the authorities. HDZero Race V3 · HDZero Freestyle V2

Band 61 allows 25 mW EIRP. The 200 mW level is above that, and 25 mW at the transmitter is also more once antenna gain is added. R1 is at 5658 MHz and therefore outside the band anyway.

For the control link, band 57c with 100 mW EIRP applies if it uses frequency hopping. ExpressLRS has its own EU build of the firmware for this, "EU_CE_2400". The source code of version 4.1.0 shows:

  • Power is limited to at most 100 mW. POWERMGNT.h
  • Above 10 mW the transmitter checks whether the channel is free before sending (Listen Before Talk). According to the code comment, the threshold is calculated from the EN 300 328 standard. LBT.cpp

You choose the build when flashing. The ISM_2400 build does not have this limit in the source code. Even with the EU build: 100 mW at the transmitter plus antenna gain is more than 100 mW EIRP.

Between 863 and 870 MHz there are many narrow sub-bands with their own rules. In the EU868 setting, ExpressLRS hops between 863.275 and 869.575 MHz. FHSS.cpp For non-specific devices the authorisation allows:

Band, frequencyLimitCondition
46a
863–865 MHz
25 mW (ERP)access and interference mitigation techniques, alternatively duty cycle ≤ 0.1 %
47
865–868 MHz
25 mW (ERP)access and interference mitigation techniques, alternatively duty cycle ≤ 1 %
48
868–868.6 MHz
25 mW (ERP)access and interference mitigation techniques, alternatively duty cycle ≤ 1 %
50
868.7–869.2 MHz
25 mW (ERP)access and interference mitigation techniques, alternatively duty cycle ≤ 0.1 %
54
869.4–869.65 MHz
500 mW (ERP)access and interference mitigation techniques, alternatively duty cycle ≤ 10 %

In between there are, among others, sub-bands for alarm systems. ERP refers to a dipole, not an isotropic radiator; according to the Bundesnetzagentur, EIRP is higher than ERP by a factor of 1.64 or 2.15 dB. Vfg. 21/2021 So 25 mW ERP is about 41 mW EIRP. Our assessment: there is no simple limit for 868 MHz that applies across the whole range. If you want a clear-cut answer, fly your control link on 2.4 GHz.

What this guide does not cover

With an amateur radio licence other rules apply, and they are not part of the authorisation for short-range devices. Where and how you may fly is covered in the guide Flying FPV legally in Germany.

Last updated: Nov 5, 2026